User Manual

Suitable for: Isuzu MU-X / D-Max
FI11967
Issue: 3 Date: 15/08/2018
15
Kit Part No: TPWKIT-006
© 2018
Under the fan control unit, dislodge and remove the lower trim (1).
Dislodge the accessory panel (2) and remove all connectors from
behind before removing.
Remove a suitable blanking cap (3) from the accessory panel (2).
3
2
1
Cut out and adhere the Switch Template (page 15) (1) to the
centre of the previously removed blanking cap (2).
Drill a Ø2mm pilot hole in the two marks on the Switch Template
(1).
Drill out the top hole to Ø3.5mm and the bottom hole to Ø10mm.
Important
Ensure the large hole on the Switch Template (1) is
adhered centrally on the blanking cap (2).
Insert the Electric Brake Switch (1) into the blanking cap (2) from
behind.
Fasten the supplied Nut (3) locking the Electric Brake Switch (1) to
the blanking cap (2). Torque the nut (3) to 0.8Nm.
Rotate the shaft (4) fully anti-clockwise and fit the knob (5) to the
shaft (4) with “0" pointing upwards as shown.
Insert the Cat 5 Cable (6) supplied in the wiring kit, into the Electric
Brake Switch (1).
Route the Cat 5 Cable (6) through the accessory panel cavity
and reassemble the accessory panel and lower trim.
1
2
4
5
1
6
Page 07 of
5
2
1
3
Step 10
Step 11
Step 12