User Manual

General Notes
Parts Supplied
Tools Required
Safety Notes
Parts Supplied
Tools Required
• Read through the fitting instructions before installation of the accessory. Install the accessory following the fitting
instructions. Failure to do so may cause damage to the vehicle or the accessory.
• Ensure all recyclable discarded vehicle accessory components are packaging are recycled following local
recycling regulations.
• It is always recommended that this accessory is fitted by a qualified automotive technician.
• Safely store and protect any removed vehicle components.
• Ensure all bare metal surfaces are protected using automotive bare metal primer and touch-up paint, or suitable
automotive rust inhibitor.
• Remove all metal swarf and dust from all vehicle surfaces if surface is used for accessory installation.
• Check that all work practices comply with safety standards.
• Please wear appropriate clothing and use safety equipment.
Electric Brake Harness x1
Cat-5 Cable 1.5m x1
200mm Cable Tie x20
900mm Cable Tie x15
4 way connector x1
M4 Screw x4 M4 Flat Washer x4 M4 Spring Washer x4 M6 Hexhead Bolt x2
M6 Flat Washer x2 Butt Splice x1
Phillips Head Screwdriver Trim Removal Tools Ratchet Socket Set Drill Drill Bit Set
Ø25mm Hole Saw / Spade
Bit
Electrical / Insulation Tape
Wire Cutters
Deburring Tool Round File
Heatshrink x1 Fitting Instructions x1
Switch Template
(Page 15) x1
Page 02 of
A B C D E F
G
M
H I
N O
J K L
ECU Bracket x1
Screwdriver Ratchet with
Phillips Head Bit
Suitable for: Isuzu MU-X / D-Max
FI11967
Issue: 3 Date: 15/08/2018
15
Kit Part No: TPWKIT-006
© 2018