User Manual
Step 22
Step 23
Step 24
• At the rear of the vehicle, disconnect the grey 8-way (1)
connector on the trailer wiring harness.
1
• Patch the grey 8-way connectors (1) from the Brake Controller
Harness (2) into the trailer wiring harness grey 8-way connectors
(3).
• Locate the ‘Blue’ wire that is taped back on the trailer wiring
harness near the 8-way connector.
• Locate the ‘Blue’ wire that is taped back on the Electric Brake
Harness.
• Cut the brass ferrule off and strip the insulation back 10mm on
both the ‘Blue’ wires.
• Slide the supplied Heatshrink over the wires before crimping
•
both
wires using the supplied Butt Splice with an indent type crimpers.
Solder the wires to the butt splice. Ensure that a good connection
is made.
• Wait for the butt splice to cool, slip heatshrink over the joint and
heat.
1
1
3
2
Page 11 of
1 2
3 4
Keep heatshrink away from joint until after soldering is
complete and cooled.
3
Suitable for: Isuzu MU-X / D-Max
FI11967
Issue: 3 Date: 15/08/2018
15
Kit Part No: TPWKIT-006
© 2018