User Manual

Suitable for: Landcruiser LC200

FI11848

Issue: 4 Date: 14/08/2018

Kit Part No: TPWKIT-005

Page 09 of

• Connect the 4-Way connector (1) from the Electric Brake Harness

to the Brake Controller ECU (2).

• Connect the supplied Cat 5 Cable (3) to the Brake Controller ECU

(2).

Step 16

Step 17

Step 18

• On the RHS of the steering column, secure the Brake Controller

bracket assembly (1) to the existing vehicle bolt (2) as shown.

• Adhere the supplied Anti-Abrasion Tape (3) to the top of the

bracket assembly (1) to prevent damage to any vehicle wires.

• Insert the Switch Insert (1) into the vacant cavity on the switch

panel (2).

Note: If the indicated switch cavity is already occupied, any other

vacant cavity can be used, including on the panel to the left of the

steering wheel.

• Insert the Electric Brake Switch (3) into the Switch Insert (1) from

behind.

• Fasten the supplied Nut (4) locking the Electric Brake Switch (3) to

the Switch Insert (1). Torque the Nut (4) to 0.8Nm.

• Rotate the shaft fully anti-clockwise and fit the knob (5) to the

shaft with “0" pointing upwards as shown.

• Route the Cat 5 Cable (6) to the switch panel area (2) and

connect to the Electric Brake Switch (3) from behind.

• Secure the excess Cat 5 Cable (6) with the supplied Cable Ties.