User Manual

Suitable for: Landcruiser LC200

FI11848

Issue: 4 Date: 14/08/2018

Kit Part No: TPWKIT-005

Step 10

• Route the Electric Brake Harness (1) over the radiator shroud

following the factory dual battery harness (2) if present.

• Secure the Electric Brake Harness (1) using the supplied Cable Ties

(3).

• If the factory dual battery harness (2) is not present, route the

Electric Brake Harness (1) in the same position.

• Route the Electric Brake Harness (1) behind the secondary battery

(2) if present.

• Continue under the air box filter bracket and towards the driver

side firewall.

• Secure the Electric Brake Harness (1) using the supplied cable ties.

• Secure the ground ring terminal from the Electric Brake Harness (1)

to the vehicle chassis grounding point (3).

Page 07 of

• Fasten the Fuse Holder positive ring terminal on the Electric Brake

Harness (1) to the positive battery terminal.

• Secure the Fuse Holder (2) to the vehicle battery harness using the

supplied Cable Ties (3).

Step 11

Step 12

Important

Ensure the vehicle positive battery terminal cover is seated

fully and correctly after installation.