User Manual

Step 4
FI11807
Issue: 5 Date: 13/08/2018
Suitable for: Hilux / Fortuner
Kit Part No: TPWKIT-004
© 2018
Step 6
Step 5
• In the passenger side footwell area, remove the white plastic cap
(1).
• Using a large screwdriver, dislodge the carpet (2).
1
2
• In the engine bay on the passenger side, remove the smaller
grommet (1).
• Insert a sharp object through the hole to pierce the firewall
insulation. Note: If required, inside the cabin use a knife to
enlarge the in hole in the firewall insulation.
• Feed the Electric Brake Harness through the grommet hole until
the grommet is seated correctly and makes a good seal.
1
• Route the Electric Brake Harness (1) towards the driver side.
1
Page 05 of
11