User Manual

Suitable for: Mitsubishi Triton
FI11705
Issue: 4 Date: 14/08/2018
Kit Part No: TPWKIT-003
Step 10
Step 11
Step 12
• Disconnect the factory vehicle 18-way connector (1).
• Patch in the Kick Panel Harness connectors (2).
• Connect the Kick Panel Harness ground ring terminal (3) to the
vehicle ground point.
Page 08 of
1
2
3
The following step is for vehicles WITHOUT a 4-way connector
already mated.
• If a 4-way male connector is not present, then use the supplied
mating 4-Way Male Connector. Using a jewellers flat head
screw driver, disengage the 4-Way Male Connectors
secondary lock (4). Ensure the secondary lock is not removed
from the connector.
• House the black wire on the kick panel harness (1) in the 4-way
Male connector (2) following orientation shown below.
• Re-engage the 4-Way Male Connector secondary lock.
• Connect the 4-way male connector to the vehicle connector
(3) and wrap using the supplied Foam Tape.
The following step is for vehicles with a 4-way connector already
mated and occupied.
• Disconnect the 4-way connectors.
• Remove the foam tape from the 4-way male connector (1)
and discard.
• Using a jewellers flat head screw driver, disengage the 4-way
male connectors secondary lock (4) Ensure the secondary lock
is not removed from the connector.
• House the black wire (2) on the kick panel harness (3) into the
4-way male connector (1) as shown below before re-engaging
the 4-way male connectors secondary lock.
• Re-join the 4-way connectors and wrap using the supplied
Foam Tape.
Terminal No. Colour
1
2
3
-
4
BLACK
-
OCCUPIED
1
2
3
2
Rear of Connector
1
2
3
4
Rear of Connector
1
2
3
4
3
1
4
Note: The colour of the wire on the
vehicle side terminal used, must
match the wire colour on the
vehicle side terminal used in Step
3.
4
Note: The colour of the wire on the
vehicle side terminal used, must match
the wire colour on the vehicle side
terminal used in Step 3.
Proceed to Step 12.
Terminal No. Colour
1
2
3
-
4
BLACK
-
-
12
© 2018