User Manual

Step 1

Step 3

Suitable for: Mitsubishi Triton

FI11705

Issue: 4 Date: 14/08/2018

Kit Part No: TPWKIT-003

Step 2

• Note down all clock and radio settings.

• In the engine bay, disconnect the negative battery terminal

(1).

• Secure the Engine Bay Harness ring terminal (1) to the positive

battery terminal (2), ensuring the ring terminal wire is routed

underneath the battery cap.

Rear view of Connector

Page 05 of

Important

Always refer to the vehicle’s Workshop Manual when

removing vehicle components.

• Locate the 4-way connector at the rear of the LHS head light.

• Disconnect and discard the blanking plug from the 4-way

connector.

• Install the Engine Bay Harness (1) black wire terminal into

position 1 of the supplied mating 4-way Male Connector, then

insert the supplied Plug Seals into the remaining cavities.

Note: If the vehicle is fitted with a Trailer Wiring Harness, then use

the existing 4-way connector. Remove the plug seal and house

the black wire terminal in position 1.

• Connect the Engine Bay Harness (1) to the vehicle head light

4-way connector (2).

Note: The colour of the wire on the

vehicle-side of the terminal must

match the wire colour on the

vehicle-side of the terminal used in

step 10 or step 11.