User Manual

Parts Supplied

Safety Notes

General Notes

Suitable for: Mitsubishi Triton

FI11705

Issue: 4 Date: 14/08/2018

Kit Part No: TPWKIT-003

•

Read through the fitting instructions before installation of the accessory. Install the accessory following the fitting

instructions. Failure to do so may cause damage to the vehicle or the accessory.

Ensure all recyclables, discarded vehicle accessory components and packaging are recycled following local recycling

regulations.

It is always recommended that this accessory is fitted by a qualified automotive Technician.

Safely store and protect any removed vehicle components.

Ensure all bare metal surfaces are protected using automotive bare metal primer and touch-up paint, or suitable

automotive rust inhibitor.

Remove all metals swarf and dust from all vehicle surfaces if surfaces is used for accessory installation.

•

Check that all work practices comply with safety standards.

Please wear appropriate clothing and use safety equipment.

Engine Bay Harness x1

B C

3-Way Male Connector

Kick Panel Harness x1

Brake Signal Harness x1

60X30X3mm Foam Tape

100X40X3mm Foam Tape

M4 Nyloc Nut x4

Secondary Lock x1

M4 Flat Washer x4

M6 Nyloc Nut x1

M6 Flat Washer x1

1.5m CAT 5 Cable x1

Switch Insert x1

Bracket x1

Plug Seal x5

200mm Cable Ties x16

900mm Cable Ties x8

Fitting Instructions x1

Page 02 of

4-Way Male Connector

3-Way Male Connector

4-Way Male Connector