User Manual

Suitable for:
Holden Colorado / Colorado 7
FI11736
Issue: 3 Date: 14/08/2018
Kit Part No: TPWKIT-002
Page 08 of
• In the LHS front wheel arch, remove the two T20 torx screws (1), five
scrivets (2) and the 10mm bolt (3).
• Release the three T20 torx screws (4) and remove the mudguard
(5).
• Remove the wheel arch lining (6) and the foam support.
4
4
5
2
2
1
2
2
6
5
Step 13
Step 14
Step 15
• In the LHS front wheel arch area, remove the vehicle grommet (1).
• Route the first grommet on the Electric Brake Harness (2) through
the vehicle grommet hole on the vehicle chassis (3) before
securing the second grommet in place.
• Continue routing the first grommet on the Electric Brake Harness
(2) into the cabin through the previously removed vehicle
grommet (1).
Note: If the first grommet hole in the chassis rail is occupied use the
alternate route (4).
Important
Ensure the Harness Grommet is seated correctly to
prevent any water ingress.
2
4
1
3
• Inside the vehicle, using the table below, house the terminals (1)
from the Electric Brake Harness into the supplied 4-Way
Connector (2), ensuring the terminals lock into the housing.
• Snap off the secondary lock (3) from behind the 4-Way
Connector (2).
• Fit the secondary lock (3) to the underside of the 4-Way
Connector (2).
Wire Colour
Terminal
1
2
3
4
Red
Blue
White
Black
Rear View of Connector
(Wire Entry Side)
4 3 2 1
2
3
3
2
1
13
© 2018