User Manual

Suitable for:

Holden Colorado / Colorado 7

FI11736

Issue: 3 Date: 14/08/2018

Kit Part No: TPWKIT-002

Step 11

Step 10

Step 12

• Insert the supplied Switch Insert (1) into the vacant cavity on the

gear shift surround trim (2).

• Insert the Electric Brake Switch (3) into the Switch Insert (1) from

behind.

• Fasten the supplied Nut (4) locking the Electric Brake Switch (3)

to the Switch Insert (1). Torque the Nut (4) to 0.8Nm.

• Rotate the shaft (5) full anti-clockwise and fit the knob (6) to the

shaft (5) with “0" pointing upwards as shown below.

• Route the Cat 5 Cable (7) to the gear shift surround trim (2) and

connect to the Electric Brakes Switch (3) from behind.

The following step is for the Colorado only, for a Colorado 7 proceed

to Step 12.

• In the LHS rear wheel area, unfasten the three T20 torx screws (1)

and remove the mudguard (2).

• Remove the four T20 torx screws (3), six scrivets (4) and the 10mm

bolt (5).

• Remove the wheel arch lining (6).

Proceed to step 13.

The following step is for the Colorado 7 only, for a Colorado refer to

Step 11.

• In the LHS rear wheel area, unfasten the three T20 torx screws (1)

and remove the mudguard (2).

• Remove the two T20 torx screws (3), five scrivets (4) and the 10mm

bolt (5).

• Remove the wheel arch lining (6).

Page 07 of