User Manual

Suitable for:
Holden Colorado / Colorado 7
FI11736
Issue: 3 Date: 14/08/2018
Kit Part No: TPWKIT-002
13
© 2018
Step 9
Step 7
Step 8
• In the glove compartment cavity, remove the vehicle 13mm
bolt (1).
• Secure the Brake Controller bracket assembly (2) to the vehicle
using the existing stud (3), the supplied M8 Nut (4) and M8
Washer (5).
• Secure the Brake Controller bracket assembly (2) in place using
the previously removed 13mm bolt (1).
Important
Refer to workshop manual for recommended torque
specifications.
*ECU not shown on bracket
2
3
1
5
4
1
• Connect the supplied Cat 5 Cable (1) to the Brake Controller ECU
(2).
2
1
1
• Route the Cat 5 Cable (1) along the dash towards the gear shift
area and secure to the existing vehicle harness using the supplied
Cable Ties.
• Remove the RHS 12v socket (2) on the gear shift surround trim.
• Secure the unused connector behind the RHS 12v socket (2) in the
vehicle using the supplied Cable Ties.
2
Important
Ensure the Cat 5 Cable (1) is secured away from any
moving parts or sharp edges.
Page 06 of