User Manual

Step 1

Suitable for:

Holden Colorado / Colorado 7

FI11736

Issue: 3 Date: 14/08/2018

Kit Part No: TPWKIT-002

Step 3

Step 2

Important

Always refer to the vehicle’s Workshop Manual when

removing vehicle components.

• Note down all clock and radio settings.

•

• Remove the LHS front scuff plate (1) and dislodge the rubber door

seal (2).

In the engine bay, disconnect and isolate the negative battery

terminal.

• Remove the LHS kick panel trim (1) by releasing the screw or

plastic nut (2).

• Squeeze both sides of the glove box compartment (1) and swing

the drawer downwards towards the footwell.

• On each bottom corner of the glove box compartment (1), pull

the drawer up and towards the seat and remove from hinges.

Note - for Colorado 7 only:

• Remove glove box by angling towards you and pulling upwards.

Page 04 of