User Manual

Suitable for:
Holden Colorado / Colorado 7
FI11736
Issue: 3 Date: 14/08/2018
Kit Part No: TPWKIT-002
Step 23
Step 22
Step 24
Page 11 of
• Locate ‘RED’ wire (1) on the trailer wiring harness socket head.
• Cut the wire 150mm from the base of the socket.
• Remove the cut ‘RED’ wire (1) from the trailer socket.
4
7
2
3
5
6
1
Pin No.
Function
Cable Colour
1
2
3
4
5
6
7
Left-hand turn signal
Reversing signal
Earth return
Right-hand signal
Service brakes
Stop lamp signal
Rear lamps, clearance and
side marker lamps
Yellow
Black
White
Green
Blue
Red
Brown
1
150mm
X
• Butt-splice and heat shrink the previously cut ‘RED’ wire on the
vehicle end, to the ‘RED/WHITE’ wire on the Electric Brake Harness.
• Slide the supplied Heatshrink over the wires before c
•
•
rimping both
wires to the supplied butt splice using indent type crimpers.
Solder the wires to the butt splice. Ensure that a good connection
is made.
Wait for the butt splice to cool, slip heatshrink over the joint and
heat.
1 2
3 4
Keep heatshrink away from joint until after soldering is
complete and cooled.
• In the engine bay, secure the ground ring terminal of the Electric
Brake Harness (1) to the vehicle ground (2) on the chassis
adjacent to the battery.
• Secure the positive ring terminal of the Electric Brake Harness (1)
to one of the posts on the side of the battery terminal under the
red cover (3).
• Secure the fuse to the harness next to the fuse box using the
supplied Cable Ties.
1
3
2
• Insert new ‘RED’ wire with brass ferrule from the Electric Brake
Harness into the same position in the trailer socket.
13
© 2018