User Manual

FORD RANGER / EVERESTSuitable for:
Kit Part No: TPWKIT-001
FI11409
Issue: 4 Date: 13/08/2018
17
© 2018
Step 27
Step 28
Step 29
If the vehicle is a Ford Ranger, refer to Step 25.
If the vehicle is a Ford Everest, continue:
5mm
Page 14 of
•
•
•
•
On the RHS rear wheel area near the exhaust hanger, locate the
OE Harness 16-way connector (1) and disconnect.
On the male connector, peel the back of the PVC tape to expose
the blue wire (2). The blue wire (2) may be up to 300mm away.
Strip 5mm of insulation from both the Electric Brake Harness (blue
wire) and the vehicle blue wire.
Route the Electric Brake Harness (blue wire) to this area.
2
• Slip the supplied Heatshrink over the wire and insert both blue
wires into the supplied Butt Splice.
• C
•
•
•
rimp both wires to the Butt Splice using indent type crimpers.
Solder the wires to the Butt Splice. Ensure that a good connection
is made.
Wait for the Butt Splice to cool, slip the Heatshrink over the joint
and heat.
Reconnect the 16-way connector (1).
Keep heatshrink away from joint until after soldering is
complete and cooled.
Proceed to Step 30.
• C
•
•
•
rimp both wires to the Butt Splice using indent type crimpers.
Solder the wires to the Butt Splice. Ensure that a good connection
is made.
Wait for the Butt Splice to cool, slip the Heatshrink over the joint
and heat.
Reconnect the 16-way connector (1).
Proceed to Step 30.
1
1
•
•
Continue routing the Electric Brake Harness blue wire (1) around
the rear of the vehicle towards the RHS rear wheel area.
Secure Harness using supplied Cable Ties along the top of the
towbar and vehicle harnesses.
1
1 2
3 4