Manual

2
INSTALLATION
Check your Sensor Part number and decide on what you intend to measure.
1. If you are measuring cabin temperature you may wish to plug the sensor directly into
the 2 way White connector that is located on the gauge harness.
2. The kit comes with an extension harness of 3 metres (approx) for GS-OWT1-4 & GS-
OWT1-8 or 6 metres (approx) for GS-UT-80 & GS-UT-120.
3. If you fi nd this cable is too short you may use any 2 core wire as an extension.
4. If you are running it through multiple connections, make sure connections are kept
clean and free of corrosion to prevent temperature measurement errors.
Your installation is now complete and programming is required so the reading can
be displayed. Refer to your Gauge programming instructions for how to enable and
calibrate your extra sensor display.