G52-PT G52-PT Single Oil Pressure 52mm Gauge (with Optional Temperature Display)* G52-PT 60 90 30 OIL 120 PSI 0 0 C *Optional Temperature Display requires the purchase of GS-UT-80 / GS-UT-120 / GS-OWT1-4 or GS-OWT1-8
WARNING & SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS - This manual contains IMPORTANT SAFETY INSTRUCTIONS for the G52-PT Gauge. DO NOT OPERATE THE GAUGE UNLESS YOU HAVE READ AND UNDERSTOOD THIS MANUAL AND THE GAUGE IS INSTALLED AS PER THESE INSTALLATION INSTRUCTIONS. NOT SUITABLE FOR MARINE APPLICATIONS. 1. The G52-PT Oil Pressure Gauge is designed to provide an accurate indication of Oil Pressure with an optional temperature indication.
INSTALLATION Find a suitable location for mounting the Gauge. REDARC offer a range of mounting solutions - refer to www.redarc.com.au . It is important to ensure that your installation meets any regulations regarding Field of View and Head Impact requirements.
OPERATING INSTRUCTIONS Selecting Gauge ID for multi-gauge systems If your gauge is part of a multi gauge system (i.e. more than one gauge) and you wish to allow programming from a single push button, connect the communication link wires together (see wiring diagram on page 2). The Gauge “Id” of all linked gauges will need to be set to unique numbers. Make sure that each gauge is set to a unique number or letter and that one gauge is set as the master “Id.0”.
FREQUENTLY ASKED QUESTIONS Centre black circle on gauge is flashing intermittently. If the black centre ring is flashing and the gauge sounds an alarm, the gauge may have been programmed to trigger a relay, but a relay is not detected. Check the relay connection or reprogram as required. If no relay output is required refer to setup mode 10 and select ‘nc’.
OPERATING INSTRUCTIONS Setup Modes (Setup mode is indicated by display of the programming symbol 60 90 30 OIL 120 PSI 0 0 C 60 90 30 OIL 120 PSI 0 0 C 60 90 30 OIL 120 PSI 0 0 C 60 90 30 OIL 120 PSI 0 0 C 60 90 30 OIL 120 PSI 0 0 C 60 90 30 OIL 120 PSI 0 0 C ) ID Select Mode / Beeps: 1 Selections: 0 to 9 & A to F (16 selections) For a single gauge setup do not change this selection as only the default selection “Id.0” allows programming of modes.
OPERATING INSTRUCTIONS Setup Modes 60 90 30 OIL 120 PSI 0 0 C 60 90 30 OIL 120 PSI 0 0 C 60 90 30 OIL 120 PSI 0 0 C Optional Temp Display Reading Adjust (Negative) Mode / Beeps: 7 Selections: Decrements by 1°C every 15 seconds Press and hold to slowly decrease the temperature reading until it matches the known temperature of the sensor. The Gauge will display ‘+’/‘-’ dependant on setting #10.
TWO YEAR PRODUCT WARRANTY Over the last three decades our company has established a reputation as the power conversion specialist. A 100% Australian-owned company, we have met the needs of customers in transport and other industries through exciting, innovative thinking.
