Product Manual

OPERATING INSTRUCTIONS
Setup Modes
Current Sensor display
Mode / Beeps: 7
Selections: 0.0 or ‘nc’
CHANGING THIS SETTING FROM ‘NC’ TO 0.0 WILL RESET THE ZERO-OFFSET OF THE CURRENT
METER. ENSURE THAT NO CURRENT IS FLOWING WHILST CHANGING THIS SETTING.
If you have installed the optional current sensor (GS-AMPS) and wish to display
current set this to 0.0, otherwise set to ‘nc’.
RECOMMENDED ACCESSORY: ENHANCED LIGHTING CONTROLLER (GA-ELC)
The REDARC Enhanced Lighting Controller is designed to enhance the lighting of your REDARC gauge. It
is to be used when you do not have a dimming circuit to connect your gauge to or the dimming circuit in
your vehicle does not dim the REDARC gauge to your liking.
The GA-ELC also allows you to program night time brightness and colour of your REDARC gauges,
including dimming if connected to a dash dimmer. Once programmed your gauges will change colour
when turning on your park lights and back to a day light colour when you turn them off.
The GA-ELC is also 24V capable and only one is required for a set of gauges.
Refer to www.redarc.com.au for more details.
7
0
10
20
30
3
5
7
4
6
A
EGT
X100
PSI
BOOST