Manual

1 INSTALLATION
CLICK
8
STEP 6.
Test the unit by switching to ‘on’ position (marked ‘1’) and checking that the indicator led is
lit. The unit should stay in the on position.
• If installed, push the remote switch. This should cause the switch to turn off (marked
‘0’). The LED will also turn off. Ensure field winding is isolated.
• If installed, Test by following Roll Over Switch (ROS) instructions.
STEP 5.
Install Remote Switch and Roll Over Sensor / Roll Over Switch (ROS) if required. Refer to
component supplier instructions.
REMOTE SWITCH
LED INDICATOR