Product Manual
8
INSTALLATION
STEP 7
In order to view the BCDC display panel LEDs, a slot must be cut out of the plastic panel before it is
refitted to the vehicle.
1. Cut out the template along the solid black line.
2. Place template with the red arrow towards the engine.
3. Align the template to the plastic panel.
4. Mark hole centres and carefully drill out the ends of the slot using a 12mm (
15
⁄
32
") drill bit.
5. Using a sharp utility knife, carefully cut out the plastic section between the drilled holes.
6. Refit the upper plastic panel.
NOTE: If you have printed the template yourself, ensure that the template has printed at the correct size
(100%) before drilling or cutting the plastic panel. Use a ruler to confirm against the reference scale
printed on the template.
STEP 8
Refit all trims and fasteners.
PERIODIC MAINTENANCE/CHECKS
Check the BCDC is clear of combustibles during regular servicing of the vehicle. Build-up of combustible
materials around the bracket and BCDC may result in a fire hazard.