Manual

7
Step 5.1
• Re-fit the vehicle horns to the radiator support panel. Both horns will now mount
together, back to back on the driver’s side factory mounting position. Note: The
front facing horn can be bent slightly forward to prevent vibration when being used.
A quick sound check will confirm placement is correct.
Step 5.3
• Fit the suitable REDARC Fuse Kit (FK40 or FK60) as close as possible to battery
according to the REDARC BCDC Instruction Manual.
BCDC1220 - Use FK40
BCDC1225D - Use FK40
BCDC1240D, 1250D - Use FK60
Step 5.4
• With the plastic cover panel
removed from the vehicle, align
the template according to the
markings.
STEP 1 Cut template
around solid outline
Place template with
arrow toward engine
STEP 3 Align edge with
bonnet latch cutout
STEP 4 Mark hole centres
and drill with M8
STEP 2 Align hole with
cut-out in plastic panel
Step 5.5
• Mark the 4 hole centres and drill with an M8 drill bit. Cut neatly between the
holes to create a viewing window for the BCDC front panel.
Step 5.6
• Sit the plastic radiator cover panel in place when BCDC wiring and mounting is
complete. Check inspection hole for alignment with the BCDC front panel, trim
plastic as required and deburr rough edges.
5 INSTALLATION (ALL VEHICLES)