Manual

5
Step 3.1
• Remove the M6 hex bolt from the passenger side of the lower grille support tab
(location indicated in Step 3.2).
Removing factory fitted screws may expose bare metal resulting in rust. Retouch
any exposed metal with rust inhibitor.
Step 3.2
• Sit the charger assembly on the
radiator support panel and align
the lower mounting foot hole. Re-
install the factory M6 hex head bolt
in the lower grille support tab to
fasten the lower foot.
Damage to cabling can cause
failure of BCDC and vehicle
electrical systems. Ensure wiring
is clear of sharp edges and moving
parts, and have enough slack to
allow for flexing.
Lower Grille
Support Tab
Step 3.3
• Use the provided M6x20 and
M8x20 Hex Head bolts with the
flanged Nylon locking nuts to
fasten the bracket to the radiator
support panel.
• Tighten the M6 bolt to 7.5 Nm and
the M8 bolt to 15Nm. Ensure the
factory bolt is correctly tightened
to the vehicle manufacturers
torque specifications.
3 INSTALLATION (10/2009 - 10/2017 VEHICLES)