Manual

6
Step 7
• Run the BCDC wiring loom behind
the bracket assembly and through
the blank hole below the two air
conditioner lines to gain access
to the engine bay. Complete the
wiring according to the BCDC
instruction manual.
Damage to cabling can cause
failure of BCDC and vehicle
electrical systems. Ensure wiring
is clear of sharp edges and moving
parts, and have enough slack to
allow for flexing.
Step 8
• Re-fit the grille to the vehicle by locating the 2 x lower plastic clips. Re-install
the 3 hex head screws in the top mounting.
Step 9
• Ensure all fasteners are tightened to the correct manufacturers torque
specifications. Ensure all wiring is fastened neatly in place and charger, bracket
and vehicle systems have appropriate clearance to prevent rubbing.
Do not cable tie wiring to air conditioner lines as damage will occur to the
aluminium pipes.
PERIODIC MAINTENANCE/CHECKS
Check the BCDC is clear of combustibles during regular servicing of the vehicle. Build-
up of combustible materials around the bracket may result in a fire hazard.
INSTALLATION