Product Manual

2
INSTALLATION
Find a suitable location for mounting the Gauge. REDARC offer a range of mounting
solutions - refer to www.redarc.com.au . It is important to ensure that your installation
meets any regulations regarding Field of View and Head Impact requirements.
Wire into vehicle as per the diagram below:
* Connect to a dash light that dims via the vehicle dimmer adjustment to ensure the gauge dims accordingly. If your
illumination circuit in your vehicle varies the positive voltage for dimming you will require an REDARC Enhanced Lighting
Controller (GA-ELC) to get the gauge to dim with your night-time driving lights.
** Ensure that the ground connection makes good contact with the vehicle ground. Poor grounding can cause incorrect
sensor readings. REDARC recommend removing any paint from the surface to ensure a bare metal on metal connection.
It is recommended that any wiring harnesses be covered using conduit or similar.
G52-VVA
Rear View
Programming
Switch
2:1 View
Secondary
Connector
2:1 View
Primary
Connector
to Dash Light
Negative*
to Park Light
Positive
Ground
Connection**
Battery 1
12V Only
Battery 2
12V Only
L
O
C
K
A
C
C
O
N
S
T
A
R
T
To Ignition
2A
fuse
2A
fuse
2A
fuse
Brown
Orange
Black Black
Yellow
Red
Brown
Grey
Purple
Multiple Gauge Communication Link
(set Gauge ID before connecting)