G52-V VA G52-V VA Dual Voltage 52mm Gauge (With Optional Current Display)* G52-V VA VOLTS 16 14 16 14 1 2 12 10 12 10 A *Optional Current Display requires the purchase of GS-AMPS
WARNING & SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS - This manual contains IMPORTANT SAFETY INSTRUCTIONS for the G52-V VA Dual Volts Gauge. DO NOT OPERATE THE GAUGE UNLESS YOU HAVE READ AND UNDERSTOOD THIS MANUAL AND THE GAUGE IS INSTALLED AS PER THESE INSTALLATION INSTRUCTIONS. NOT SUITABLE FOR MARINE APPLICATIONS. 1. 2. 3. 4. The G52-VVA Dual Volts Gauge is designed to provide an accurate indication of two voltages and an optional current indication.
INSTALLATION Find a suitable location for mounting the Gauge. REDARC offer a range of mounting solutions - refer to www.redarc.com.au . It is important to ensure that your installation meets any regulations regarding Field of View and Head Impact requirements.
OPERATING INSTRUCTIONS Selecting Gauge ID for multi-gauge systems If your gauge is part of a multi gauge system (i.e. more than one gauge) and you wish to allow programming from a single push button, connect the communication link wires together (see wiring diagram on page 2). NOTE: The Gauge “Id” of all linked gauges will need to be set to unique numbers BEFORE the gauges are connected together. Make sure that each gauge is set to a unique number or letter and that one gauge is set as the master “Id.0”.
FREQUENTLY ASKED QUESTIONS I cannot get the relay output feature to work. The G52-VA and G52-V VA are not equipped with a relay output feature. All other gauges within the range include this feature. Why is the centre ring flashing? The centre ring will flash if setup mode number 4 is incorrectly set. For the G52-VVA, setup mode number 4 should be set to ‘none’ (no pointer showing). I cannot get the ‘peak hold’ feature to work. The G52-VA and G52-V VA is not equipped with the peak hold feature.
OPERATING INSTRUCTIONS Setup Modes (Setup mode is indicated by display of the programming symbol VOLTS 16 16 14 14 1 2 12 12 10 10 A VOLTS 16 16 14 14 1 2 12 12 10 10 A VOLTS 16 16 14 14 1 2 12 12 10 10 A 16 14 14 1 2 12 12 10 ID Select Mode / Beeps: 1 Selections: 0 to 9 & A to F (16 selections) For a single gauge setup do not change this selection as only the default selection ‘Id.0’ allows programming of modes.
RECOMMENDED ACCESSORY: ENHANCED LIGHTING CONTROLLER (GA-ELC) If the illumination circuit in your vehicle varies the negative voltage for dimming, the brown wire can be connected to a dash light and will dim the gauge accordingly. If the dimming circuit in your vehicle does not dim the REDARC gauges to your liking, a REDARC Enhanced Lighting controller (GA-ELC) will be required.
AUSTRALIAN TWO YEAR PRODUCT WARRANTY Over the last three decades our company has established a reputation as the power conversion specialist. A 100% Australian-owned company, we have met the needs of customers in transport and other industries through exciting, innovative thinking.
