Operation Manual

RED DSMC OPERATION GUIDE: WEAPON

CONNECT WIRELESSLY TO A DEVICE VIA INFRASTRUCTURE MODE

In Infrastructure mode, the camera and your device both connect to an access point, and communicate through

that wireless network. To connect the camera to your device via an existing wireless network, follow the

instructions below:

1. Connect your device to a wireless network. The access point for the network must have DHCP enabled.

2. Make sure that you know the name and password for the network, since you will need that information to

connect the camera to the same network.

3. Go to Menu > Settings > Setup > Communication.

4. Select the WiFi tab.

5. Select Infrastructure from the Mode drop-down menu.

6. Select Scan to search for available wireless networks.

The available wireless networks (access points), their encryption types, and their signal strengths display.

The camera can connect to access points that are either not encrypted or use WPA or WPA2 encryption. If

an encrypted access point is selected a passphrase field will appear to enter the password.

7. Select the wireless network that your device is connected to.