Operation Manual

COPYRIGHT © 2015 RED.COM, INC
RED DSMC OPERATION GUIDE: WEAPON
955-0116_V6.1, REV-E | 50
TC INDICATOR
The TC indicator shows the current timecode status.
 Gray: No analog timecode is detected.
 Red: Analog timecode is detected but not enabled.
 Green: Analog timecode is used to jam the time of day timecode.
For more information, go to “Timecode, Genlock, Multi-Camera Setup” on page 132.
GEN INDICATOR
The GEN indicator shows the current genlock status.
 Gray: No genlock signal is detected, or the signal cannot cross-lock to project (24.00 FPS vs. 23.98 FPS).
 Red: During process of sync, or genlock is lost while recording.
 Green: A genlock signal matching the current HD-SDI monitor rate is locked.
 Yellow: Timing is cross-locked to compatible but not matching monitor rate. For example, genlock is 24.00
FPS, and HD-SDI monitor rate is 25.00 FPS.
NOTE: When the GEN indicator is yellow, DO NOT perform 3D operation. This warns that genlock source
settings and camera settings are not aligned, so phasing of the sync between cameras is not guaranteed.
For more information, go to “Timecode, Genlock, Multi-Camera Setup” on page 132.
SYNC INDICATOR
The SYNC indicator shows the current sensor sync status, based on genlock.
 Gray: The sensor sync mode is not set to genlock.
 Red: The sensor sync mode is set to genlock, but is not locked to a genlock signal. This may occur if
genlock or sensor sync is lost while recording.
 Green: The sensor sync mode and HD-SDI monitor rate are locked to a compatible genlock signal.
For more information, go to “Timecode, Genlock, Multi-Camera Setup” on page 132.
LAN INDICATOR
NOTE: The GIG-E port is only available on the WEAPON REDVOLT Expander. For more information, go to “Input/
Output Connectors” on page 161.
The LAN indicator shows the current status of an external LAN connection through the Gig-E port.
 Gray: External control of the camera is not enabled.
 Yellow: If the LAN indicator is yellow, external camera control is not possible. For more information, go to
“Cannot Control Camera Externally” on page 145.
WIFI INDICATOR
The WiFi indicator shows the WiFi status.
 Gray: WiFi is disabled.
 Yellow: WiFi is not connected.
 Green: WiFi is enabled.
For more information, go to “WiFi” on page 95.