Operation Manual

RED DSMC OPERATION GUIDE: WEAPON

955-0116_V6.1, REV-E | 36

REMOVE THE MEDIA BAY

To troubleshoot issues with the media bay or SSD, you may need to remove and re-install the media bay. Unless

you are troubleshooting media-related issues, DO NOT remove the media bay.

WARNING: Before installing or removing the media bay, you MUST turn off the BRAIN.

REQUIRED TOOL: T10 TORX driver

1. Turn off the BRAIN.

2. Loosen the four (4) captive screws in a cross pattern (“X” pattern) using a T10 TORX driver.

3. Remove the media bay from the BRAIN.

4. Inspect the connections and pins on the BRAIN and ensure that they are clean and undamaged.

NOTE: DO NOT touch any part of the exposed boards or connectors.

5. Re-attach the media bay as soon as possible to prevent dust or debris from entering the BRAIN. For more

information, go to “Install the Media Bay” on page 36.

INSTALL THE MEDIA BAY

WARNING: Before installing or removing the media bay, you MUST turn off the BRAIN.

REQUIRED TOOL: T10 TORX driver

1. Turn off the BRAIN.

1. Place the media bay on the BRAIN, so that the mounting holes of the media bay align with the screw holes

of the BRAIN.

2. Use a T10 TORX driver to tighten the four (4) captive screws by about two (2) turns in a cross pattern (“X”

pattern). DO NOT FULLY TIGHTEN.

3. Tighten the four (4) captive screws evenly. DO NOT exceed 70 in-oz, or damage may occur.

WARNING: DO NOT OVERTIGHTEN.

INSTALL THE FOCUS HOOK

For more information on the focus hook storage location and mounting point, go to “BRAIN Connectors, Focus

Hook, and Back Focus” on page 16.

REQUIRED TOOL: Slotted screwdriver

1. Remove the focus hook from the focus hook storage location on the media bay using a slotted screwdriver.

2. Tighten the focus hook into the focus hook mounting point on the media bay using a slotted screwdriver.

WARNING: DO NOT OVERTIGHTEN.