Operation Manual

RED DSMC OPERATION GUIDE: WEAPON
COPYRIGHT © 2015 RED.COM, INC 955-0116_V6.1, REV-E | 35
INSTALL THE WEAPON REDVOLT XL MODULE
The WEAPON REDVOLT XL Module mounts to the rear of the following items:
 WEAPON BRAIN
 WEAPON Base Expander
 WEAPON REDVOLT Expander
WARNING: Before installing or removing the WEAPON REDVOLT XL Module, you MUST turn off the BRAIN.
REQUIRED TOOL: T20 TORX driver
1. Turn off the BRAIN.
2. Position the module on the rear of the BRAIN or expander, aligning the connector on the front of the module
with the connector on the rear of the BRAIN or expander.
3. Apply pressure and tighten the four (4) captive screws in a cross pattern (“X” pattern) approximately two (2)
turns each using a T20 TORX driver. DO NOT FULLY TIGHTEN.
4. Fully tighten the four (4) screws in a cross pattern (“X” pattern) using a T20 TORX driver.
WARNING: DO NOT OVERTIGHTEN.
REMOVE THE WEAPON REDVOLT XL MODULE
WARNING: Before installing or removing the WEAPON REDVOLT XL Module, you MUST turn off the BRAIN.
REQUIRED TOOL: T20 TORX driver
1. Turn off the BRAIN.
2. Loosen the four (4) captive screws in a cross pattern (“X” pattern) using a T20 TORX driver.
3. Remove the module from the BRAIN or expander.
INSTALL THE WEAPON TOP HANDLE
WARNING: Before installing or removing the WEAPON Top Handle, you MUST turn off the BRAIN.
REQUIRED TOOL: 3/16" hex key
1. Turn off the BRAIN.
2. Position the WEAPON Top Handle on top of the BRAIN, aligning the connector on the bottom of the
WEAPON Top Handle with the connector on top of the BRAIN.
3. Tighten the two (2) captive screws approximately two (2) turns each using a 3/16" hex key. DO NOT FULLY
TIGHTEN.
4. Fully tighten the two (2) screws using a 3/16" hex key.
WARNING: DO NOT OVERTIGHTEN.
REMOVE THE WEAPON TOP HANDLE
WARNING: Before installing or removing the WEAPON Top Handle, you MUST turn off the BRAIN.
REQUIRED TOOL: 3/16" hex key
1. Turn off the BRAIN.
2. Loosen the two (2) captive screws using a 3/16" hex key.
3. Remove the WEAPON Top Handle from the BRAIN.