Operation Manual

RED DSMC OPERATION GUIDE: WEAPON

955-0116_V6.1, REV-E | 134

INPUT EXTERNAL TIMECODE

This section explains how to set up your camera so that it accepts timecode generated by an external device.

This procedure requires a WEAPON Base Expander.

NOTE: Inputting timecode requires a WEAPON Base Expander. For more information, go to “Input/Output

Connectors” on page 161.

1. Connect the external timecode generator to the camera using a 3BNC-to-00 LEMO

Sync Cable.

A. Connect the yellow BNC connector to the output on the timecode generator.

B. Connect the 00B LEMO connector to the SYNC port on the WEAPON Base Expander.

2. Go to Menu > Settings > Project > Timecode.

3. Select the desired Timecode Display Mode.

4. Set Source to External.

The TC indicator in the Lower Status Row turns green when an external timecode source is locked.

NOTE: When an external source is selected but not present, timecode displays User Provided settings.

REQUIRED CABLE

 790-0154: 3BNC-to-00 LEMO Sync Cable

Source: External: BRAIN