Operation Manual

RED DSMC OPERATION GUIDE: WEAPON
COPYRIGHT © 2015 RED.COM, INC 955-0116_V6.1, REV-E | 109
REDISCOVER (HARDWARE REDISCOVER)
Rediscovers all hardware and caches the data for future boot cycles. Perform a Hardware Rediscover if a
module or lens mount is not functioning correctly.
To perform a Hardware Rediscover, follow the instructions below:
1. Go to Menu > Settings > Maintenance.
2. Select Rediscover.
3. Select Yes on the screen that asks you to confirm the Hardware Rediscover.
The BRAIN turns off.
4. Turn on the BRAIN.
SYSTEM STATUS
The System Status menu displays key project and system information on the following tabs: Project Status,
Camera Info, Media Info, Attached Modules.
PROJECT STATUS
Displays the current camera and project settings.
CAMERA INFO
Displays the following camera information:
 Type: Camera type and sensor type.
 Firmware Version: Current firmware version.
 PIN: The personal identification number that is specific to your camera.
 SVN Revision: The current firmware number.
 Runtime: The number of hours that the camera has been turned on.
MEDIA INFO
Displays the following media information:
 Active Media: Active media, module type.
 Model Number: Storage capacity, SSD type, and version/revision of the SSD.
 Serial Number: Serial number of the SSD.
 Firmware Version: Firmware version of the SSD.
 Size: Total capacity on the SSD.
 Size Available: Total capacity left on the SSD that can be recorded to.
NOTE: When an SSD is not attached, the Media Info tab displays “No Active Media is Present”.
ATTACHED MODULES
Lists the attached RED modules, lens mounts, and expanders. This screen does not list attached displays,
media modules, and lenses.
MEDIA MENU
The Media Menu allows you to format and eject an SSD and to view and load clips on the SSD.
For more information about using media, see the DSMC Media Operation Guide, available at www.red.com/
downloads.