Operation Manual

RED SCARLET-X OPERATION GUIDE

955-0003_v4.0, Rev-A | 225

SLAVE CAMERA

Perform the following steps on the Slave camera:

Go to SECONDARY MENUS > SETTINGS > SETUP > COMMUNICATION > NAME and give the camera a

unique NAME (CAM B, RIGHT, etc…).

Under TARGET select NONE.

Give the Slave camera a unique IP address different from the Master.

CLIP NAMING CONVENTIONS

REEL NO. / SLATE (CAMERA ID) / CAMERA POSITION

Before shooting in Master / Slave or Master / Master configuration for a Stereo / 3D production, make sure

the Camera Slate (i.e. Reel No. and Cam ID) are set to the same value for both Master and Slave cameras.

Then change the Cam Pos value from the system default of CENTER, to either LEFT or RIGHT to identify the

"left eye" and "right eye" camera in the stereo pair.

The Reel No, Cam ID and Cam Pos can be set when formatting the media or after formatting by using the

SET option. Refer to SECONDARY MENUS > MEDIA.