Operation Manual

MAIN MENU

Available options under the MAIN MENU are FRAMERATE (FPS), ISO (SENSITIVITY), F STOP, 1/SEC

(EXPOSURE), WHITE BALANCE, RESOLUTION, and QUALITY (REDCODE).

FPS

If using a Touch Screen, select SECONDARY MENUS > SETTINGS > PROJECT > TIME BASE. Adjust by

sliding your finger up / down or tapping on the desired value, and then press anywhere else on the touch

screen to confirm.

The following TIME BASES are currently available:

• 23.98 fps

• 24.00 fps

• 25.00 fps

• 29.97 fps

• 47.96 fps

• 48.00 fps

• 50.00 fps

• 59.94 fps

NOTE: A project can only support one Time Base as this defines the frame count to be used for

time code and as the clip playback and editing frame rate. It is also the primary frame rate for

acquisition, but variable speed (over-crank and under-crank) recordings can be made above and

below this base frame rate using the VARISPEED menu.

VARISPEED

When a frame rate other than the current TIME BASE has been selected, the FPS text will turn Yellow

and VARISPEED will be shown where the Audio Meter is normally displayed at the lower right of the

display.