Operation Manual

3. While applying steady pressure to hold the module against the adaptor plate, use a T-20 Torx

screwdriver to rotate the lock on the adapter plate clockwise to secure the module.

Installation is now complete.

To remove the DSMC Module and Adaptor Plate:

1. Power down the camera.

2. Use a T-20 Torx screwdriver to rotate the lock on the adapter plate to the Unlock position.

3. Rotate the module upwards and down to disengage lip at top of module from adaptor plate.

4. Remove module from adapter plate.

5. Use a T-20 to loosen the screws attaching the adaptor plate the camera brain.

6. Remove the adaptor plate from the camera brain.

REDMOTE

This section describes the physical controls on the REDMOTE. For complete details on REDMOTE

control, refer to APPENDIX E: REDMOTE OPERATION.

IMPORTANT: For your REDMOTE to operate with this camera build version, ensure your REDMOTE

has been upgraded to the latest firmware. Refer to APPENDIX E: REDMOTE OPERATION >

MAINTENANCE > UPGRADING REDMOTE FIRMWARE.

Rotate Lock Clockwise

Until Red Dot Lines Up

with Lock Icon

Press Battery Module

Flush with Adaptor