Operation Manual

4. Using a T-20 Torx, lightly tighten the four screws. Do not over tighten.

5. Tighten the screws again in a cross pattern until tight.

ATTACHING THE DSMC MODULE

WARNING: DSMC Modules are NOT hot swappable - meaning you cannot remove or install while

the camera is powered on. Before installing or removing a Module, you MUST power down the

camera. Failure to do so may result in damage to the Module and / or camera brain that is not

covered by warranty.

Quad Battery Module shown.

1. Insert the lip at the top of the module into the recess at the top of the adaptor plate.

2 3