Operation Manual

Version 2.0.5R1
DECEMBER 20, 2011 ©2011 RED.COM INC.
221
BACK FOCUS ADJUSTMENT
WARNING: THERE IS A SCREW-IN METAL PLUG INSTALLED IN THE CAMERA BODY COVERING
THE BACK FOCUS SCREW. THIS PLUG
MUST BE REMOVED
NOTE: To be able to perform this procedure as written, you must have a PL mount and RED
Focus™.
BEFORE TO PERFORMING A BACK
FOCUS ADJUSTMENT. TO REMOVE THE PLUG, USE A T-10 TORX DRIVER.
Back focus is adjusted by turning the back focus adjustment on the top of the camera’s front plate using
a T-10 Torx driver. This screw is indicated by a Siemens Star with an arrow pointing to its location.
Back Focus Adjustment Location – EPIC-M Shown, Scarlet-X Similar
1. Remove the screw-in plug located in the back focus adjustment opening using a T-10 Torx driver.
2. Place the camera on a level, stable surface or mount the camera on a tripod.