Operation Manual

Version 2.0.5R1

202 202

APPENDIX F: 3D SETUP / OPERATION

OVERVIEW

The following information outlines basic procedures to connect two (2) RED SCARLET-X cameras

together in a Master / Slave configuration for 3D operation, operation of cameras in Master / Slave

configuration and clip naming conventions for clips recorded on those cameras. The MASTER camera

will control only the METADAT parameters of both cameras. On the SLAVE camera, any other setting

outside of these will need to be manually changed before recording.

CAMERA SETUP

Select one camera to be designated as Master and a second to be designated as Slave.

NOTE: Cameras can be set up in a MASTER / MASTER and SLAVE / SLAVE configuration. To set

as MASTER / MASTER select ALL under TARGET for both cameras. This will allow either camera

to make changes and control record start/stop of both cameras. To set as SLAVE / SLAVE select

NONE under TARGET for both cameras.

MASTER CAMERA

Perform the following steps on the Master camera:

1. Go to SECONDARY MENUS > SETTINGS > SETUP > COMMUNICATION > NAME and give the

camera a unique NAME (CAM A, LEFT, etc…).

2. Under TARGET select ALL.