Operation Manual

Version 2.0.5R1

183

If no camera is found, REDmote will go into IDLE mode and display “Camera: RESCAN…”

When the camera is turned back on, the REDmote will not automatically pair (if the REDmote is left

powered up or is powered up before the camera).

1. To reconnect REDmote to the camera (assuming the camera and REDmote have been paired

before):

a. If the “Camera: RESCAN…” is NOT displayed, press Soft Menu Button 1 under CONNECT. The

REDmote will display “Searching”.

b. If the “Camera: RESCAN…” is displayed, press the ENTER button. The REDmote will display

“Searching”.

2. When a camera is found, the REDmote will display “Camera: RESCAN…” and below that the name

and MAC address (in parenthesis) of the camera.

NOTE: If more than one camera has been connected wirelessly to this REDmote, multiple

cameras may be listed.