Operation Manual

Version 2.0.5R1

177

CONNECTING / REMOVING

This section describes how to physically connect / remove the REDmote to / from an SCARLET-X or

SCARLET-X Brain or to / from the back on an expansion module. On the lower left and right sides of the

REDmote are V-lock release buttons (B, M) that must be depressed to release the REDmote from the

camera or module.

PHYSICAL

CONNECTING (DOCKING)

1. Place the female V-Mount of the REDmote over the male V-Mount of the camera/module.

2. Press down until a click is heard which indicated the REDmote is securely attached.

3. The REDmote will confirm by displaying “DOCKED” momentarily (if REDmote is ON when docked).

NOTE: If the camera is ON and the REDmote is OFF, the REDmote will automatically power UP

when connected.