Owner manual
Table Of Contents
- REDRAY PLAYER Operation Guide
- Table of Contents
- Disclaimer
- REDRAY Overview
- REDRAY Setup
- REDRAY Operation
- REDRAY Settings
- Troubleshoot the REDRAY
- Technical Specifications
- Encode Clips with RRencode
- REDcommand App
- REDRAY Menu Map
- IR CONTROL PROTOCOL

COPYRIGHT © 2014 RED.COM, INC
REDRAY PLAYER OPERATION GUIDE
955-0017, REV-D | 8
REAR PANEL
97 10
1 2 43
8
11
5
6
# REAR PANEL ELEMENT DESCRIPTION
1 802.11 Connector For use with the included 802.11 Antenna
2 AUDIO OUT
(HDMI 1.3 connector)
Audio output (Stereo and 5.1 Ch), 24-bit, 48kHz uncompressed LPCM
3 HDTV OUT
(HDMI 1.3 connector)
Video output at up to 12-bit 4:2:2 YCbCr, 1920 x 1080p resolution
4 USB/E-SATA Reserved for future use
5 NETWORK
(RJ45)
(Upper) GigaBit Ethernet network interface port
(Lower)
2
Reserved for future use
6 VID A OUT
(HDMI 1.4 connector)
Video output at up to 12-bit 4:2:2 YCbCr, 4096 x 2160p resolution
7 VID B OUT
(HDMI 1.4 connector)
Video output at up to 12-bit 4:2:2 YCbCr, 4096 x 2160p resolution
8 VID C OUT
(HDMI 1.4 connector)
Video output at up to 12-bit 4:2:2 YCbCr, 4096 x 2160p resolution
9 VID D OUT
1
(HDMI 1.4 connector)
Video output at up to 12-bit 4:2:2 YCbCr, 4096 x 2160p resolution
10 GPI
2
Reserved for future use
11 AC Power Switch and
Connector
IEC 3-pin, 100-240 VAC, 50-60 Hz, 1A max. at 100VAC
1. This is the primary 4K connector. Use this connector when connecting the REDRAY PLAYER to a 4K display using a single HDMI cable.
2. These connectors have been disabled on the REDRAY Player.
Rear Panel