User guide

Build 31 v31.6.16

109

SECONDS

Allows the operator to enter new value for seconds. Range 0 – 59.

SET CLOCK

Set Clock loads the selected Date and Time parameters into the camera’s system memory.

NOTE: After pushing this key the camera will require re-boot as displayed. The new parameters will

take effect, and be visible as TIME CODE, on completion of the re-boot cycle.

REMOTE

Used to enable (and reset if necessary) the S4/i Lens Data Port. Controls include REMOTE PORT and

LENS PORT check box.

REMOTE PORT

Allows you to select between S4/I and AUX 232 (default is S4/i).

S4/i

Select S4/i to enable communication between the RED ONE and an S4/i compatible lens, and to enable

recording of the lens data as metadata in the RED ONE .R3D files. Refer to LENS DATA under DISPLAY

located in PREFERENCES under SETUP in SYSTEM MENU SETTNGS.