THIS PAGE INTENTIONALLY BLANK
TABLE OF CONTENTS DISCLAIMER .................................................................................................................................................. 2 Copyright Notice ...................................................................................................................................... 2 COMPLIANCE ................................................................................................................................................
DISCLAIMER RED® has made every effort to provide clear and accurate information in these Installation Instructions, which is provided solely for the user’s information. While thought to be accurate, the information in this document is provided strictly “as is” and RED will not be held responsible for issues arising from typographical errors or user’s interpretation of the language used herein that is different from that intended by RED.
JAPAN STATEMENTS EUROPEAN UNION COMPLIANCE STATEMENTS Red declares that the equipment described in this document has been tested is in conformance with the requirements of the European Council EMC Directive 2004/108/EC, Low Voltage Directive 2006/95/EC, RoHS Directive 2002/95/EC and WEEE Directive 2002/96/EC.
BEFORE YOU START READ FIRST RED® is providing the following installation instructions as a special service to our customers for the option of upgrading your RED ONE camera from a CF Module to a RED ONE 1.8” SSD Module. Please understand that any damage that occurs to your camera, CF Module or RED ONE 1.8” SSD Module while installing your RED ONE 1.8” SSD Module IS NOT covered under warranty. If you want RED to perform the installation of the RED ONE 1.8” SSD Module for you, RED will do so free of charge.
REMOVING CF MODULE 1. Place the RED ONE camera body on its side (connector side down) on the protected surface so that the CF Module with the word RED facing you. CF Module 2. Using a 2.5mm Allen wrench, remove the four (4) CF Module Allen Screws. NOTE: When removing the Allen screws from the CF module, be sure to remove the small lock washers as they may stay in the CF module mounting holes after removing the Allen screws.
3. Gently rotate the CF Module to allow access to the two (2) connectors. 4. Disconnect the Serial ATA and e-SATA connectors by carefully pulling on the connector itself. CAUTION: DO NOT pull on the harness or yank on the CF module to disconnect the Serial ATA and e-SATA connectors. This may damage the harness, connectors, CF Module and/or components inside the RED ONE camera body. Damage that occurs to your camera, CF Module or SSD Module while installing your RED ONE 1.
INSTALLING RED ONE 1.8” SSD MODULE 1. Carefully connect the Serial ATA and e-SATA connectors to the RED ONE 1.8” SSD Module. NOTE: Connectors are installed in the opposite direction as when connected to the CF Module. Carefully Plug In Both Connectors 2. Place the RED ONE 1.8” SSD Module on the RED ONE camera body. CAUTION: Ensure the harnesses are not pinched or damaged during installation. 3. Install the existing Allen Screw Lock Washers (4) onto the NEW Allen Screws (4). 4.
5. Tighten to specification in a diagonal order. Tighten Allen Screws to 4 in lbs (0.45 N.m) 4 2 3 1 6. The RED ONE 1.8” SSD Module installation is complete. 8 ©2010 RED.COM, INC.
INSTALLATION VERIFICATION PROCEDURE Verify proper operation of the RED ONE 1.8” SSD Module by performing the following: 1. Power up the RED ONE. 2. Insert a RED 1.8” SSD MAG into the RED ONE 1.8” SSD Module. “SLOW MEDIA” displays on the Camera’s LCD and “Unformatted” displays in the lower left corner of the external display(s) until the RED 1.8” SSD MAG is formatted.
