Technical data

Version 3.0
955-0003_V3.0, REV-A ©2011-2012 RED.COM INC.
197
SETUP
CONFIGURING REDMOTE CONNECTION WITH COMPUTER (MAC ONLY)
The first step in upgrading REDmote firmware is to establish communication between the MAC and the
REDmote.
1. Connect a USB to mini-USB cable between the computer and the USB connector on the REDmote.
2. Go to System Preferences and choose Network. This may open automatically when the REDmote is
connected.
3. Look for a device called RNDIS/ ...Gadget.
4. Change Configure IPv4 setting to “Manually” (as shown).
5. In the IP Address field, enter 192.168.0.1 (as shown).
6. The Status should change to “Connected” after changes.