Specifications

224 224

BACK FOCUS ADJUSTMENT

WARNING: THERE IS A SCREW-IN METAL PLUG INSTALLED IN THE CAMERA BODY COVERING

THE BACK FOCUS SCREW. THIS PLUG

MUST BE REMOVED

Back Focus Adjustment Location

BEFORE PERFORMING A BACK

FOCUS ADJUSTMENT. TO REMOVE THE PLUG, USE A T-10 TORX SCREWDRIVER.

NOTE: To perform this procedure as written, you must have a PL mount and RED Focus™.

Back focus is adjusted by turning the back focus adjustment on the top of the camera’s front plate using

a T-10 Torx screwdriver. This screw is indicated by a Siemens Star with an arrow pointing to its location.

1. Remove the screw-in plug located in the back focus adjustment opening using a T-10 Torx

screwdriver.

2. Place the camera on a level, stable surface or mount the camera on a tripod.

3. Install RED Focus to the camera PL mount.

a. Remove the camera lens or sensor cover if equipped.

b. Install RED Focus onto the camera in the position shown.

c. Ensure RED Focus is secured to the camera with the camera lock ring.

RED Focus Properly Installed on Camera