UPGRADE Owner manual

DSMC FAN 2.0 UPGRADE INSTRUCTIONS

955-0012, REV-D | 25

9. Use a 3mm Allen wrench to tighten the four (4) M4 screws by about two (2) turns. DO NOT FULLY TIGHTEN.

10. Fully tighten the 1/4-20 screws. DO NOT OVERTIGHTEN.

11. Tighten M4 screws in a cross pattern. DO NOT OVERTIGHTEN.

12. Reattach any DSMC accessories that you removed from the BRAIN.

13. Upgrade your firmware or perform a hardware rediscover to ensure that your camera recognizes the new

fan. For more information, go to “Configure Firmware” on page 26.

NOTE: The top fan may not run immediately after turning on the DSMC, as the top fan runs only when the

DSMC requires additional cooling power.

NOTE: If you need to replace any screws, please contact your Bomb Squad representative.

Install M4 Screws