Specifications

RED DSMC OPERATION GUIDE

955-0020_V5.2, REV-K | 94

CAMERA NAME

Use the Camera menu to set up a unique identifier for your camera (or a group of cameras). All command

filtering happens on the receiver side of the communication link. Use camera names and group names to

address commands to a specific camera or group of networked cameras.

 Name: Enter a unique camera name to use in network communications. The field is limited to eight (8)

characters.

 Group: Enter a group name to identify the camera as a member of a group of devices. The field is limited to

eight (8) characters, and the default name is DEFAULT.

 Target: Specify which devices the camera can send commands to:

‒ All: The camera can send commands to all devices on the network.

‒ None: The camera can only receive commands. The camera cannot send commands.

‒ Custom: The camera can send commands to a specific camera/device (enter the name of the camera/

device in the Custom text box) or a specific group (enter the name of the group in the Custom text box).

The camera/group name must match the name entered in the Name/Group field of the target device(s).

SERIAL PROTOCOL

The camera can communicate to external devices via the CTRL and the GIG-E connectors (camera-to-camera

communication is possible only via GIG-E or the REDLINK Bridge).

Select one of the following protocols from the Serial Protocol drop-down menu:

 None (Default)

 Element Technica

 3ality SPC 7XXX

 REDLINK Command Protocol

 RCP 3D Metadata