Specifications

COPYRIGHT © 2014 RED.COM, INC
RED DSMC OPERATION GUIDE
955-0020_V5.2, REV-K | 42
8. Use an LED light to ensure that the optical cavity is clean and free from dust or debris.
9. Ensure the desired OLPF module is clean and free of debris.
10. Insert the OLPF module.
11. Replace and loosely tighten the four (4) M2x0.4 x 4 mm OLPF module screws in a cross pattern (“X” pattern)
using a T6 Torx driver. DO NOT FULLY TIGHTEN.
12. Fully tighten the four (4) OLPF module screws in a cross pattern (“X” pattern) using a T6 Torx driver. DO
NOT exceed 30 in-oz, or damage may occur.
WARNING: DO NOT OVERTIGHTEN.
13. Replace the lens mount.
Ensure optical cavity
is clean and free of
debris
Replace the OLPF
module and screws