Owner's manual

RED 3-AXIS SYSTEM OPERATION GUIDE

RED START/STOP CABLE (1B TO 00B SYNC)

The RED Start/Stop Cable (1B to 00B Sync) supports Start/Stop functionality through the RED W.M.D. This

cable connects to the EXP port on the W.M.D. and to the SYNC port of your DSMC and is ideal for run-and-gun

shooters who want convenient Start/Stop capability only.

NOTE: When using the RED Start/Stop Cable (1B to 00B Sync), you must configure the W.M.D. for EPIC start/

stop operation only. On the W.M.D., go to Select > Start/Stop > EPIC.

NOTE: For use for direct Start/Stop applications. Eliminates Timecode, Genlock, and Tally options.

W.M.D. EXPANSION PORT EPIC START/STOP

FGG-1B.314.CLAD42Z FGG-00.304.CLAD35Z

PIN SIGNAL WIRING PIN SIGNAL

1 GND 1-1 1 GND

2 232 Rx_In - 2 EPIC Start/Stop

3 +12 V - 3 Timecode In

4 232 Tx-Out - 4 Genlock

5 Start/Stop

Contact Pin

- - -

6 Start/Stop

Status in 3V3

- - -

7 Epic Start/Stop

3.3 Con Pin

7-2 - -

8 AUX GPIO 1_3.3 - - -

9 +3.3 V - - -

10 Cable ID - - -

11 - - - -

12 AUX GPIO 2_3.3 - - -

13 - - - -

14 - - - -

RED Start/Stop Cable (1B to 00B

Sync)