Owner's manual

RED 3-AXIS SYSTEM OPERATION GUIDE

955-0044, REV-D | 68

RED START/STOP CABLE (1B TO BNC)

The RED Start/Stop Cable (1B to BNC) provides Start/Stop, Genlock, and Timecode support. This cable con-

nects to the EXP port on the W.M.D. and an auxiliary device for Start/Stop, Genlock and Timecode.

NOTE: Full support requires the 3BNC-to-00 LEMO Sync Cable and a BNC-TO–BNC Adaptor (included with the

RED 3-Axis Lens Control System).

W.M.D. EXPANSION PORT EPIC START/STOP

FGG-1B.314.CLAD42Z BNC

PIN SIGNAL WIRING PIN SIGNAL

1 GND 1-Shield Shield GND

2 232_Rx - Coax EPIC Start/Stop

3 +12 V - - -

4 232_Tx - - -

5 Momentary

Start/Stop

- - -

6 EPIC Tally - - -

7 EPIC Start/Stop 7-Coax - -

8 AUX GPIO 1_3.3 - - -

9 +3.3 V - - -

10 Cable ID - - -

11 - - - -

12 AUX GPIO 2_3.3 - - -

13 - - - -

14 - - - -

RED Start/Stop Cable (1B to BNC)