Owner's manual

RED 3-AXIS SYSTEM OPERATION GUIDE

RED START/STOP CABLE (1B TO SYNC, CTRL, BNC)

The RED Start/Stop Cable (1B to Sync, Ctrl, BNC) provides Start/Stop, Tally, Genlock and Timecode support.

This cable connects to the EXP port on the W.M.D. and the CTRL port of your DSMC, with an additional BNC

for jamming Timecode.

NOTE: Full support requires the 3BNC-to-00 LEMO Sync Cable and a BNC-TO–BNC Adaptor (included with the

RED 3-Axis Lens Control System).

W.M.D. EXPANSION PORT EPIC START/STOP

FGG-1B.314.CLAD42Z BNC

PIN SIGNAL WIRING PIN SIGNAL

1 GND 1-Shield Shield GND

2 232_Rx 2-4 Coax EPIC Start/Stop

3 +12 V - - -

4 232_Tx 4-2 - -

5 Momentary

Start/Stop

EPIC CTRL PORT

6 EPIC Tally 6-3

FGG.00.304.CLAD35Z

7 EPIC Start/Stop 7-Coax 2 RS232 Rx

8 AUX GPIO 1_3.3 - 3 EPIC Tally

9 +3.3 V - 4 RS232 Tx

10 Cable ID - - -

11 - - - -

12 AUX GPIO 2_3.3 - - -

13 - - - -

14 - - - -

RED Start/Stop Cable (1B to

Sync, Ctrl, BNC)